improving its sensitivity of hybrid control of remote control part for container truck system -金沙贵宾厅

for g.t. power container truck lighting and voice vibration system pro, some players suggested that we should improve its sensitivity of hybrid control of remote control part in order to let players control more functions through remote controller . we’ve attached great importance to this matter and already made improvement. the new hybrid control of manual and remote controller both have these functions: turn on/off dangerous alarm light ,turn on fog lamp or roof lamp, switch gear, switch the functions of the third channel, stop engine etc.we are looking forward to your good suggestions and ready to make improvements at any time.thank you for your support.

you can download updated file from any inquiries, please feel free to contact with our tech. support(email：bill@gt-rc.com).

detailed update steps listed as below:

1.power on and turn on the device, do not start the throttle, use microusb cable connect to computer,will appear two removable disk,choose and click open the disk which capacity about 15m, you will find file team_01 showed as below,copy provided file 098.wav to file team_01,after finished disconnect usb cable.

2.put the control board switch to off position, after light off, press and hold down mode select key and light sw key till put the control board switch to on position, all light off.connect usb cable to computer, computer will show update inform, open it and you will find contents as below, copy update file firmwarev2.7.1.gtp to it, finish and disconnect power.

3.power on the device again, if the remote control calibration data is lost, it may need to be re-calibrate.through cellphone app connect device to check if firmware version is 2.7.1, if yes, finished, if not, update again.